・Material: Special tool steel (manufactured by Kobe Steel) ・Total length: Approx. 95mm ・Weight: Approx. 50g ・Blade hardness: HRC58 or above・Single-edged specification
・Safety clip to prevent blade breakage・Stopper to prevent excessive opening・Spring-loaded・Soft grip・Equipped with original pliers cap (with hook)
●Cutting capacity
・Supported materials: Can only cut plastics (PS resin, PP resin, ABS resin, PE resin).
・Cutting ability: can only cut support materials smaller than Φ3mm. However, since transparent and translucent PS resin is relatively hard, it is limited to less than Φ2mm.
—Notes—
・This is a precision plier that values sharpness, so the blade may crack or break if used improperly.
・The target object can be cut with just a little force, so be careful not to hold it with excessive force.
・The blade becomes thinner toward the tip and is more likely to break closer to the tip, so use the middle part of the blade as much as possible for cutting.
・Do not twist the blade when removing it from the runner during cutting or after cutting. Twisting will cause the blade to break under the load.
・Do not use to cut objects that exceed the length of the blade. The load will be applied to a point in the middle of the blade, causing it to break or bend.
・Do not use to cut thicker plastic than the cutting capacity, or for materials that cannot be cut (metal, resin, paper, etc.).
・Do not use to cut plastic sheets, cut labels, cut parts, or cut rivets, etc.
・Remove chips adhering to the blade with a toothbrush (blade brush), etc. during and after use.
If you cut with chips remaining on the blade, excessive load will be applied to the cut material, causing damage.
Especially when using, if chips are caught on the bottom of the blade, there is a high possibility that the moving parts will loosen.
・Do not touch the tip of the "cutting edge" directly with your hands. The "cutting edge" is a very sharp blade, and there is a risk of injury if you touch it directly.
・Sebum causes rust. If you come into direct contact with metal parts, wipe off fingerprints, etc. and apply rust-proof oil.
・Humidity also causes rust, so apply oil frequently during the rainy season, etc.
・If the lubrication performance of moving parts decreases, the shaft will be worn and loose, resulting in a loss of sharpness.
Please lubricate moving parts regularly.
・To ensure safety, please wear safety glasses when using.
・There is a risk of the cut object being blown away. Please operate after making sure that there are no people and fragile objects around.
・Please keep out of the reach of children.
・When not in use, pay attention to safety and fasten the included pliers caps.
